+- PINE64 (https://forum.pine64.org)
+-- Forum: ROCKPRO64 (https://forum.pine64.org/forumdisplay.php?fid=98)
+--- Forum: RockPro64 Hardware and Accessories (https://forum.pine64.org/forumdisplay.php?fid=102)
+--- Thread: Pine64 NAS fan problems (/showthread.php?tid=7326)
Pine64 NAS fan problems - User 11259 - 03-30-2019
Hello all,
I'm new to this forum and hope you guys can help me figure out what I'm doing wrong.
I bought some parts from the Pine64 shop:
- ROCKPro64 4GB Single Board Computer
- Fan for ROCKPro64 Metal Desktop/NAS casing
- ROCKPro64 Metal Desktop/NAS Casing
- ROCKPro64 12V 5A EU POWER SUPPLY
- ROCKPro64 PCI-e to Dual SATA-II Interface Card
- ROCKPro64 20mm Mid Profile Heatsink
I got it all set up pretty quickly thanks to this well done guide here:
https://www.youtube.com/watch?v=_UeeklKo0Og
my only issue is, that the fan won't start spinning when the RockPro boots and I can't figure out why.
Sorry for the Imgur link but the three pictures are too big for the allowed 2.93mb
https://imgur.com/gallery/ax9zBXw
Although I don't think so and the slot says "FAN" right next to it did I plug the fan into the wrong slot?
Any help would be much appreciated
RE: Pine64 NAS fan problems - mabs - 03-30-2019
Hi,
this should help you .
https://github.com/tuxd3v/ats#install
Kind Regards
M
RE: Pine64 NAS fan problems - User 11259 - 03-30-2019
(03-30-2019, 10:19 AM)mabs Wrote: Hi,
this should help you .
https://github.com/tuxd3v/ats#install
Kind Regards
M
Hi thank you very much for your answer and your time.
I followed the instructions and was able to configure the profile a little to my needs and it works like a charm.
I may be wrong but where else could I have found these information? Maybe it's worth a comment or two in the "official" NAS case build guide here:
http://wiki.pine64.org/index.php/NASCase
Again thank's a lot for your time. With your help I'm now able to complete my project!
RE: Pine64 NAS fan problems - g_t_j - 04-13-2019
(03-30-2019, 04:10 PM)biomodixHow does your biuld performs? Impressions? Wrote:How does your build performs?(03-30-2019, 10:19 AM)mabs Wrote: Hi,
this should help you .
https://github.com/tuxd3v/ats#install
Kind Regards
M
Hi thank you very much for your answer and your time.
I followed the instructions and was able to configure the profile a little to my needs and it works like a charm.
I may be wrong but where else could I have found these information? Maybe it's worth a comment or two in the "official" NAS case build guide here:
http://wiki.pine64.org/index.php/NASCase
Again thank's a lot for your time. With your help I'm now able to complete my project!
Impressions? Speed? Reliability?