08-09-2016, 07:54 AM
Based on the PDF attached to the post at http://forum.pine64.org/showthread.php?t...38#pid1238, I have been able to test all the pins as output by lighting a LED.
However, I noticed that the LED isn't as bright when I use any of the PL pins. I don't have much experience here so could anyone explain the reason for this?
I also couldn't get PL10 to work at all as the LED wouldn't come on. All other pins on the Pi2, Euler and Exp bus work fine, however. Could this be a problem with my board or is there something I have to set to use this as an output pin?
Just for reference, these are the PL pins I tested
GPIO Pin No.
PL10 362 8 (Pi 2)
PL9 361 27 (Pi 2)
PL8 360 28 (Pi 2)
PL11 363 7 (Euler)
PL7 359 2 (Exp)
However, I noticed that the LED isn't as bright when I use any of the PL pins. I don't have much experience here so could anyone explain the reason for this?
I also couldn't get PL10 to work at all as the LED wouldn't come on. All other pins on the Pi2, Euler and Exp bus work fine, however. Could this be a problem with my board or is there something I have to set to use this as an output pin?
Just for reference, these are the PL pins I tested
GPIO Pin No.
PL10 362 8 (Pi 2)
PL9 361 27 (Pi 2)
PL8 360 28 (Pi 2)
PL11 363 7 (Euler)
PL7 359 2 (Exp)
