Does latest Tow-Boot install/work correctly for everyone?

[dukla2000]

...

So I'm curious now if anyone else has had this or a similar issue when trying to install tow-boot through SD installer or writing directly to mtd0 from within a booted OS. I'd raise it as an issue on the Github, but I want to be sure I haven't overlooked any potential solutions and I know @samueldr has indicated he isn't able to be as active in maintaining/troubleshooting as before.

Not what you asked, but pine64-pinephonePro-2022.07-006 worked fine for me on my PPP. 35Mb spi.installer.img was dd'd to a tatty old SD on my RPro64 then that booted fine on my PPP and I could do the install.

Same RK3399 ...

FWIW my SDcard looks like (on the RPro64)

Code:

$ lsblk
...
mmcblk1      179:96   0   3.7G  0 disk
├─mmcblk1p1  179:97   0    12M  0 part
└─mmcblk1p2  179:98   0    22M  0 part /run/media/chris/57f8f4bc-abf4-655f-bf67-946fc0f9f25b

Are you sure you have the correct bits held/flicked/switched to get your PBP booting from the SDcard?

On the basis there isn't that much difference between the boards would be tempted to at least try the PPP and/or RPro64 Tow-Boots - at least you should get to the Tow-Boot menu, whether you actually flash is another call. But would eliminate that the PBP download is a duffer.