(08-18-2016, 06:27 PM)woogerboy21 Wrote: The driver being loaded by ubuntu states the following:
[ 14.565211] RTL871X: module init start
[ 14.575894] RTL871X: rtl8723bs v4.3.16_13854.20150410_BTCOEX20150119-5844
[ 14.589926] RTL871X: build time: Jul 16 2016 11:00:09
[ 14.602062] RTL871X: rtl8723bs BT-Coex version = BTCOEX20150119-5844
[ 14.749480] RTL871X: module init ret=0
But I'll have to take the case its in apart and see if the chips model matches yours. @MarkHaysHarris777 Did you purchase your's from the store in the more recent months?
I've a similar output on debian, BUT that is the module/driver for the wifi, not the ethernet!! (which is a RTL8723BS chip on my pine64). On an early kickstarter board.
Code:
[ 12.958692] RTL871X: module init start
[ 12.968042] RTL871X: rtl8723bs v4.3.16_13854.20150410_BTCOEX20150119-5844
[ 12.980728] RTL871X: build time: May 26 2016 18:35:23
[ 12.991474] RTL871X: rtl8723bs BT-Coex version = BTCOEX20150119-5844
[ 13.161934] RTL871X: module init ret=0The only ethernet specific lines I can place atm are these:
Code:
[ 1650.374748] libphy: 1c30000.eth: probed
[ 1650.379157] sunxi-gmac 1c30000.eth eth0: eth0: PHY ID 001cc915 at 0 IRQ poll (1c30000.eth-0:00)
[ 1656.281411] libphy: 1c30000.eth-0:00 - Link is Up - 1000/Full