Connecting the RaspBee ZigBee module to 5V/GND on the Euler bus causes issues
#1
Hello,

I am trying to use the RaspBee ZigBee Module with my P64-LTS and wanted to connect it to uart3 / uart4 on the Euelr bus and power it with the 5V/GND pins on the Euler header. I power my P64 LTS via the 3.5mm Barrel Power and I also connect the official 7"LCD via the DSI connector

The pinout of the module

I wired the module with cables as follows:

Module    Euler

pin  8      pin 24 (uart3 tx)
pin 10     pin 23 (uart3 rx)
pin  2      pin  8 (5V)
pin  6      pin  6 (GND)

As sonn as I plug the power the board produces a "whining noise" and is not booting. The LCD is complete white and the small green LED is flickering and not very bright. As long as I use external 5V supply for the Module and disconnect it from 5V/GND on the Euler bus the board boots normally and I can access the module via the uart.
  Reply


Possibly Related Threads…
Thread Author Replies Views Last Post
  Wi-Fi signal issues, randomly disconnecting Little_Johnny 0 1,126 11-21-2020, 05:45 AM
Last Post: Little_Johnny
  Camera module with Android Kam 4 2,076 11-21-2020, 01:26 AM
Last Post: Little_Johnny
  Camera module with Arch Linux IkerST 0 734 05-05-2020, 08:44 PM
Last Post: IkerST
  Zwave module on LTS saileshrajk 2 1,968 01-15-2018, 11:34 PM
Last Post: tllim
  is it possible to connect 2 Ethernet port to SOPINE module? eddylai 2 2,112 05-03-2017, 12:01 PM
Last Post: bobpaul
  Sopine Module and USB HDMI mbt28 1 1,780 01-23-2017, 08:13 AM
Last Post: MarkHaysHarris777

Forum Jump:


Users browsing this thread: 1 Guest(s)