+- PINE64 (https://forum.pine64.org)
+-- Forum: PINE A64-LTS / SOPINE Compute Module (https://forum.pine64.org/forumdisplay.php?fid=66)
+--- Forum: P64-LTS / SOPINE Hardware, Accessories and POT (https://forum.pine64.org/forumdisplay.php?fid=70)
+--- Thread: Connecting the RaspBee ZigBee module to 5V/GND on the Euler bus causes issues (/showthread.php?tid=13671)
Connecting the RaspBee ZigBee module to 5V/GND on the Euler bus causes issues - karlitos - 04-22-2021
Hello,
I am trying to use the RaspBee ZigBee Module with my P64-LTS and wanted to connect it to uart3 / uart4 on the Euelr bus and power it with the 5V/GND pins on the Euler header. I power my P64 LTS via the 3.5mm Barrel Power and I also connect the official 7"LCD via the DSI connector
The pinout of the module
I wired the module with cables as follows:
Module Euler
pin 8 pin 24 (uart3 tx)
pin 10 pin 23 (uart3 rx)
pin 2 pin 8 (5V)
pin 6 pin 6 (GND)
As sonn as I plug the power the board produces a "whining noise" and is not booting. The LCD is complete white and the small green LED is flickering and not very bright. As long as I use external 5V supply for the Module and disconnect it from 5V/GND on the Euler bus the board boots normally and I can access the module via the uart.