PINE64   ›   Pinebook Pro   ›   Pinebook Pro Hardware and Accessories   ›   eMMC to USB adapter "very" slow at reading data

Thread Closed 
eMMC to USB adapter "very" slow at reading data
talpa
Pine Initiate
**
Joined: Mar 2020
Posts: 18

Reputation: 0
#3
07-08-2020, 07:50 AM (This post was last modified: 07-08-2020, 08:22 AM by talpa.)
(07-08-2020, 06:36 AM)roncromberge Wrote: Adapter is only usb2!


Verzonden vanaf mijn iPhone met Tapatalk

Yes, but shouldn't USB 2 theoretically (aka. marketing lies) be capable of ~50MB/s
According to the data sheet of the GL823 interface chip used it should support both 1 and 4 bit transfers.

However it also states a typical "SD/MMC Card Clock Frequency" of 48MHz i "High Speed Mode" which leaves one with 24MB/s of raw bandwidth to the eMMC if the interface runs in 4x mode.

I suppose protocol overhead could drop this down to 13-16 MB/s :o/
Thread Closed 


Messages In This Thread
RE: eMMC to USB adapter "very" slow at reading data - by talpa - 07-08-2020, 07:50 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Anyone selling a spare NVMe adapter in Europe? tom.tomasz 1 791 01-03-2022, 07:57 AM
Last Post: tom.tomasz
  Mini-Howto: ROCK64 USB 3.0 WIFI Adapter (Rabbit-ear) on Manjaro Dendrocalamus64 1 1,275 11-14-2021, 03:41 PM
Last Post: Dendrocalamus64
  eMMC failed Dendrocalamus64 9 3,023 11-12-2021, 11:08 AM
Last Post: Dendrocalamus64
  Upgrade eMMC card - boot problems alpopa 0 1,613 09-16-2020, 12:31 PM
Last Post: alpopa
  128GB eMMC support dgkPBP 7 5,832 09-08-2020, 07:36 AM
Last Post: KC9UDX
  Manjaro 20.06 requires multiple boots from eMMC to launch successfully on PBP Spectre 0 1,640 07-09-2020, 06:12 PM
Last Post: Spectre
  LTE adapter via NVMe grego 2 3,538 07-08-2020, 01:37 PM
Last Post: manawyrm
  Pro NVMe adapter Does not fit ! ? bcnaz 110 78,547 07-03-2020, 10:51 PM
Last Post: xmixahlx
  m.2 adapter board screw missing? screamy 4 4,192 07-01-2020, 08:37 PM
Last Post: screamy
  SSD Adapter MIA noeman5 3 3,322 06-16-2020, 09:21 AM
Last Post: noeman5

Forum Jump:


Users browsing this thread: 1 Guest(s)