08-04-2020, 03:20 PM
Hi,
I'm using a Pine64 with Raspbian and everything is fine.
My project uses the UART4 and as I have a device with very specific and short timing I developped a Linux Line Discipline for that.
Everything is still Ok, but I'm facing an issue (maybe a newbie issue...) I cannot get RTS line (pin18 / PD4) controlled, neither from C from inside ,my line disciple neither from python with PySerial.
BTW, to veryfy I've connected a bitscope to lines Euler2 pins 18-19-21 and I see the signal on pins 19 & 21 (Tx & RX), but desperately nothing on pin 18 (RTS).
Are the RTS/CTS lines activated on the device or should I add an overlay for that? Or at least where to check?
Any clue?
I'm using a Pine64 with Raspbian and everything is fine.
My project uses the UART4 and as I have a device with very specific and short timing I developped a Linux Line Discipline for that.
Everything is still Ok, but I'm facing an issue (maybe a newbie issue...) I cannot get RTS line (pin18 / PD4) controlled, neither from C from inside ,my line disciple neither from python with PySerial.
BTW, to veryfy I've connected a bitscope to lines Euler2 pins 18-19-21 and I see the signal on pins 19 & 21 (Tx & RX), but desperately nothing on pin 18 (RTS).
Are the RTS/CTS lines activated on the device or should I add an overlay for that? Or at least where to check?
Any clue?