HP_JACK not activated at power-up

[gbjensen]

I can't get any output signal at the I2S output, hope my bug report will fix this.
But until this is solved would I like to use the HP_Jack for audio output.  

The output do only work if the connector is inserted after power-up. if the jack plug is inserted before power up, will the output not be activated. I have tested it with Remix and android.

At the schematic is there a note2: Mount R100 3.3K This resistor is a very small 0402 resistor (less and 1*2mm)
I can't see where is it should be located at the PCB. 
   
Do anyone know if this issue will be solved if R100 is mounted (if not mounted already)?
   

[xalius]

http://forum.pine64.org/showthread.php?tid=807

[gbjensen]

http://forum.pine64.org/showthread.php?tid=807

Hi xalius,

How do I run these scripts with a Remix installation?

I have tested if a 3.3K resistor between pin 3 and GND will make any difference. No still no audio output unless I do a unplug - plug operation at the HP_JACK output.

The link to IRC chat do not work for me.

[xalius]

Hi, sorry can't really help with Remix/Android since I have no clue how the sound system there works... the IRC chat link should work, sometimes the webclient is not reachable for a couple minutes though...

[gbjensen]

A manual short circuit of pin 3 and 4 reset the HP_JACK audio output. when the short circuit is removed is the audio output activated.
I will now see if I can write an app or a small script to do this (setting / resetting a GPIO pin controlling a analog SW device and thereby make the short circuit)

[toyshop]

A manual short circuit of pin 3 and 4 reset the HP_JACK audio output. when the short circuit is removed is the audio output activated.
I will now see if I can write an app or a small script to do this (setting / resetting a GPIO pin controlling a analog SW device and thereby make the short circuit)

Have you figured a way to make this work yet? As the audio jack loses connection on reboot or even shutting down and reopening the app using it in Android, I also need to figure a way to keep connection with it without removing and plugging back in to the audio jack. I am trying to use the pine for Square POS instead of a tablet.