Flashing gone wrong

[erg]

You don't say which image you were trying to flash or which instructions you tried to follow. You should still be able to boot JumpDrive from the SD then reflash. If you look at the instructions carefully you'll see that they almost always say to dd to the raw device, not to a partition on it.

I flashed JumpDrive to the SD. Booted the phone, plugged into the laptop. I see two disks: /dev/sdd (sd card) and /dev/sdc with partitions /dev/sdc1 and /dev/sdc2
Now, if I try and do:

Code:

dd if=image.img of=/dev/sdc

I get: No space left on the device.
I try and peek with fdisk:

Code:

fdisk /dev/sdc

and there is one partition, size 10M, I also see this suspicious message:

Code:

GPT PMBR size mismatch (10854399 != 20479) will be corrected by write.

It doesn't get corrected by a write though. If I delete the partition within, save and exit and open it again, warning is still there.

Code:

fdisk /dev/sdc1

shows me two partitions:

Code:

Device       Start      End  Sectors  Size Type
/dev/sdc2p1  16384   266239   249856  122M EFI System
/dev/sdc2p2 266240 10852351 10586112    5G Linux filesystem

That's why I tried:

Code:

dd if=image.img of=/dev/sdc2

, because it looks like a separate drive to me. I guess I'm wrong?

I'm flashing it with arch with plasma