01-31-2022, 01:30 PM
(01-31-2022, 01:17 PM)gamerminstrel Wrote: A good case like you're hoping for would need to be made by a 3rd party company that has the know-how and R&D team to make that happen. Pine64 isn't nearly a big enough name for a company like Otter to take notice, so my hopes aren't raised. I think its a miracle we have *any* cases for it.
Hmm that's what i feared - but isn't there some phone close enough in dimensions to the pinephone to make it possible.
Or what about a 3d printed back case that extends the Pinephone dimensions a bit and offers a nice fat front 'lip'. If there was a case that has a large extrusion around edge of the front of the phone that should prevent cracks when dropped on flat surfaces I think?