Can't get Mobian on PinePhone to recognise USB-C docking bar
05-04-2021, 05:46 AM
(This post was last modified: 05-04-2021, 05:47 AM by duncan_bayne.)
Hi Folks 
I recently purchased a USB-C docking bar and a new convergence-capable PinePhone motherboard, and fitted the new motherboard last weekend. The Braveheart owner's discount was much appreciated too
I'm running the Mobian nightly build from 2021-05-02.
When I plug in the USB-C docking bar, it just charges the phone; no peripherals are detected (I have a keyboard, monitor, and trackball connected to the bar). Instead I get the following in dmesg:
I've tried upgrading to the linux-image-5.11-sunxi64 kernel, and flashing the ANX7688 firmware as per these instructions, but to no avail.
Anyone have any suggestions? I suspect I'm missing something blindingly obvious.
Yours,
Duncan
I recently purchased a USB-C docking bar and a new convergence-capable PinePhone motherboard, and fitted the new motherboard last weekend. The Braveheart owner's discount was much appreciated too
I'm running the Mobian nightly build from 2021-05-02.
When I plug in the USB-C docking bar, it just charges the phone; no peripherals are detected (I have a keyboard, monitor, and trackball connected to the bar). Instead I get the following in dmesg:
Code:
[ 494.616801] anx7688 1-0028: DATA role change requested to UFPI've tried upgrading to the linux-image-5.11-sunxi64 kernel, and flashing the ANX7688 firmware as per these instructions, but to no avail.
Anyone have any suggestions? I suspect I'm missing something blindingly obvious.
Yours,
Duncan
