01-04-2021, 03:52 PM
(12-29-2020, 03:43 PM)joelspangler Wrote: My current glue gun will melt the foam at it's 100w setting, but isn't hot enough at it's 60w setting... i usually wind up switching it between it's settings several times during my project. Something like a 500w pinegun or pinehotglue or PineHoG with almost the same software as the pinecil would be WONDERFUL to have.
I really doubt that even 60W wouldn't be sufficient if it just were properly regulated. It's a ton of heat already. Half a kilowatt would be a total overkill, that's vaporization-tier heat on full blast.
