12-10-2020, 12:23 PM
I'm having a similar issue.
When I insert an SD card with jumpdrive0.6 on it and try to power up, nothing happens. Sometimes the rear camera LED flashes once, but nothing else. I've tried with two SD cards, a 128MB and a 64GB.
If I "dd if=/dev/zero of=/dev/mmcblk0" then the device powers up fine. I can also see the SD card in lsblk. "dd if=/dev/zero of=/dev/yoursdcard bs=446 count=1" did nothing.
If I insert the jumpdrive0.6 SD into the slot after powering on, I can see the jumpdrive partition as well.
I have the 3GB RAM PostMarketOS Community edition, all updates done. I have full-disk encryption enabled.
Any ideas?
When I insert an SD card with jumpdrive0.6 on it and try to power up, nothing happens. Sometimes the rear camera LED flashes once, but nothing else. I've tried with two SD cards, a 128MB and a 64GB.
If I "dd if=/dev/zero of=/dev/mmcblk0" then the device powers up fine. I can also see the SD card in lsblk. "dd if=/dev/zero of=/dev/yoursdcard bs=446 count=1" did nothing.
If I insert the jumpdrive0.6 SD into the slot after powering on, I can see the jumpdrive partition as well.
I have the 3GB RAM PostMarketOS Community edition, all updates done. I have full-disk encryption enabled.
Any ideas?