05-01-2016, 03:26 AM
Last week I received my Pine64 with 2GB RAM. My journey has been very smooth with this product. I installed Debian following the instructions on the site. Installation was surprisingly easy with zero problems. I then ported my application that I built for Raspberry Pi and again I had no trouble finding all dependencies and compiling my application (C++). Another nice experience.
I then connected my Z-Wave USB Z-Stick, tested my iOS app, my sensors, etc. and again everything worked fine in the first shot.
A couple of hours after I opened the package, I have everything running on the new Pine64. My home-grown home automation solution is now powered by Pine64.
Good job and thanks so much to everyone involved in the hardware and software development of this product. The acrylic case looks as good as the one on the site. Yay!
I then connected my Z-Wave USB Z-Stick, tested my iOS app, my sensors, etc. and again everything worked fine in the first shot.
A couple of hours after I opened the package, I have everything running on the new Pine64. My home-grown home automation solution is now powered by Pine64.
Good job and thanks so much to everyone involved in the hardware and software development of this product. The acrylic case looks as good as the one on the site. Yay!