04-30-2016, 04:02 AM
(04-30-2016, 03:53 AM)tkaiser Wrote: Did you try to power the board through the pins on the Euler connector? And use the serial console from the EXP header pins (since then they can't backpower the board which leads to all sorts of strange behaviour and might be related to the problem you're running into)
The debug board is only connected to the Euler connector via GND, TX and RX, the board is powered via the micro USB port.
There's also jumper for DC5V/BAT (J1 is schematics I think) that was set to BAT by default. So I've tried changing it to DC5V, or removing it, but the result is the same.
I've also made sure to disconnect all devices with only power and serial, but no luck.
Maybe I just have a faulty board.