Bravehart w/ ubports v 48 boot loop
(06-17-2020, 03:53 PM)VaZso Wrote: I have just updated UBPorts on my Bravehear edition after about a week.
The battery was drained while the phone was powered off for a few dats, but it was in charge for about one or two minutes before update.
Update has finished, but I have received the same reboot loop.
I thought it has not enough power to boot up because the drained battery, so I pulled out my SDCard which has the OS and left it on charger for a while.
Then it was able to boot up.
However, it would be good to do something - so like an initial check at boot time then if the battery is low then just enable charging or wait while there is not enough charge.
...so a drained battery would not cause a boot loop...
The charging negotiation seems to have changed recently, I used to get quite fast charges on a usb-c charger with a proper usb-c cable, now it just negotiates 0.5A charging. Using a cheap, dumb (i.e. its just a bit of cable with some plugs) usb-c cable I get a 3.5A charge rate, but when it reaches full charge, it switches to a zero charge rate, then stays there until the battery is totally discharged, so if I leave it plugged in overnight it's empty in the morning. formerly with the "real" usb-c cable it used to charge up to full power quite quickly then drop maybe 10% then recharge again, which is what I was expecting. It may just be a problem with the original cable (same behaviour is happening in Mobian) but that cable charges my PBP quite happily.
Edit: Also it doesn't now recognise a usb-c to usb-a cable on 2.4A charger. I just booted 52, ( It actually booted in response to plugging in the charger) and 10 mins later the battery screen is showing less charge than when I started(screen off the whole time), and not indicating charging. If I re-plug it while on that screen it switches to say charging.