Bravehart w/ ubports v 48 boot loop
06-17-2020, 03:53 PM
I have just updated UBPorts on my Bravehear edition after about a week.
The battery was drained while the phone was powered off for a few dats, but it was in charge for about one or two minutes before update.
Update has finished, but I have received the same reboot loop.
I thought it has not enough power to boot up because the drained battery, so I pulled out my SDCard which has the OS and left it on charger for a while.
Then it was able to boot up.
However, it would be good to do something - so like an initial check at boot time then if the battery is low then just enable charging or wait while there is not enough charge.
...so a drained battery would not cause a boot loop...
The battery was drained while the phone was powered off for a few dats, but it was in charge for about one or two minutes before update.
Update has finished, but I have received the same reboot loop.
I thought it has not enough power to boot up because the drained battery, so I pulled out my SDCard which has the OS and left it on charger for a while.
Then it was able to boot up.
However, it would be good to do something - so like an initial check at boot time then if the battery is low then just enable charging or wait while there is not enough charge.
...so a drained battery would not cause a boot loop...