06-16-2020, 12:06 PM
The problem with "internal privacy switches" is they are "internal" You must open your device every time you wish to change them.
If you are the adventuresome type, perhaps a push-on push-off switch could be added somewhere on the case ?
a small switch may not be that hard to add, there is a wider than average bezel around the screen on the PineTab.
The microphone for example has a twisted pair of wires (I think) that would not be too difficult to extend those wires to a switch.
a ribbon cable would be slightly more complex to 'tap into' or a module soldered on the board would be very complex for a 'end user' to work with.
The PineTab is not 'sealed' up, so a small extra hole is not really going to compromise the the integrity.
If you are the adventuresome type, perhaps a push-on push-off switch could be added somewhere on the case ?
a small switch may not be that hard to add, there is a wider than average bezel around the screen on the PineTab.
The microphone for example has a twisted pair of wires (I think) that would not be too difficult to extend those wires to a switch.
a ribbon cable would be slightly more complex to 'tap into' or a module soldered on the board would be very complex for a 'end user' to work with.
The PineTab is not 'sealed' up, so a small extra hole is not really going to compromise the the integrity.
LINUX = CHOICES
**BCnAZ**
Donate to $upport
your favorite OS Team
**BCnAZ**
Donate to $upport
your favorite OS Team