12-31-2019, 01:34 PM
I just tried yet another assortment of screws. I have had some luck with using M2x4mm for the short screws and M2X6mm for the longer ones. These are cross recessed flat-head machine screws.
I still would really like to know what the original screws were supposed to be and I am still looking for appropriate spacers. I saw hrmullers message with measurements, but I haven't found anything appropriate around here yet.
I note that these screws I bought are all attracted (magnetic) to the screwdriver, whereas about half of the original ones were not.
As I mentioned before, I'd really like to buy an additional bottom cover, so that I can play with cutting a hinged port , to make using the switches/buttons and removing/replacing the EMMC easier.
I still would really like to know what the original screws were supposed to be and I am still looking for appropriate spacers. I saw hrmullers message with measurements, but I haven't found anything appropriate around here yet.
I note that these screws I bought are all attracted (magnetic) to the screwdriver, whereas about half of the original ones were not.
As I mentioned before, I'd really like to buy an additional bottom cover, so that I can play with cutting a hinged port , to make using the switches/buttons and removing/replacing the EMMC easier.