* Excellent Daniel ! *
I was thinking along the same lines on shortening the adapter board.
Also the 'cable tie' is probably better suited to the warm interior than tape.
..> (and there will not be any glue residue if you need to service it later)
I had been thinking of a metal band (like an aluminum soda can) about 1cm (3/8") wide
with the folds at the edge of the adapter board, squarely bent so it would not touch the edges of the SSD.
>( Perhaps a tape or paper insulator between the band and the SSD ) ?
* The re-routing of the track pad ribbon cable shows nice attention to detail.
*** Great Picture
Thank you for sharing ! !
I am very curious what the clearances are from there to the case ..?
perhaps a very small ball of clay, set on a piece of paper (so it does not stick to anything)
One to check the clearance form the SSD to the case and one to check clearance from the adapter to the case..?
install the bottom case, then remove it and measure the clay... ?
After measuring, possibly use a thermal pad to send heat to the case..?
(I heard there are measurments but I have not found them)
I was thinking along the same lines on shortening the adapter board.
Also the 'cable tie' is probably better suited to the warm interior than tape.
..> (and there will not be any glue residue if you need to service it later)
I had been thinking of a metal band (like an aluminum soda can) about 1cm (3/8") wide
with the folds at the edge of the adapter board, squarely bent so it would not touch the edges of the SSD.
>( Perhaps a tape or paper insulator between the band and the SSD ) ?
* The re-routing of the track pad ribbon cable shows nice attention to detail.
*** Great Picture
Thank you for sharing ! !
I am very curious what the clearances are from there to the case ..?
perhaps a very small ball of clay, set on a piece of paper (so it does not stick to anything)
One to check the clearance form the SSD to the case and one to check clearance from the adapter to the case..?
install the bottom case, then remove it and measure the clay... ?
After measuring, possibly use a thermal pad to send heat to the case..?
(I heard there are measurments but I have not found them)
LINUX = CHOICES
**BCnAZ**
Donate to $upport
your favorite OS Team
**BCnAZ**
Donate to $upport
your favorite OS Team