11-07-2019, 03:28 AM
Check if the UART switch is turned on (you need to open the PBP for this). You are looking for No9 right next to the battery connector:
https://wiki.pine64.org/index.php/Pinebo...nd_Buttons
You can grab an SD card and try a couple of builds quickly without affecting the installed distro on the eMMC (you can do this purely to find if it's something with the settings):
- Check ayufan's Ubuntu build
- Check with a clean install of the stock Debian build
I think a few people found that it was trying to pass the audio through hdmi or something along those lines.
To check the audio, try using Chromium instead of Firefox (not sure if FF's sandboxing of the audio is still an existing problem or not)
As I'm waiting for my DHL notice and don't have the device at hand atm, I can only throw a few suggestions
You can try to search the messages on Discord's channel as well.
https://wiki.pine64.org/index.php/Pinebo...nd_Buttons
You can grab an SD card and try a couple of builds quickly without affecting the installed distro on the eMMC (you can do this purely to find if it's something with the settings):
- Check ayufan's Ubuntu build
- Check with a clean install of the stock Debian build
I think a few people found that it was trying to pass the audio through hdmi or something along those lines.
To check the audio, try using Chromium instead of Firefox (not sure if FF's sandboxing of the audio is still an existing problem or not)
As I'm waiting for my DHL notice and don't have the device at hand atm, I can only throw a few suggestions
You can try to search the messages on Discord's channel as well.