06-06-2019, 11:49 AM
(This post was last modified: 06-06-2019, 12:42 PM by Tim Jones.
Edit Reason: It was a bad eMMC
)
Any further news on this? I still can't boot from 190531 via 64GB eMMC. I've tried flashing with Etcher and by using dd and the un-xz'd image with the same result.
Is there anything that I can provide to assist? As mentioned before the armbian variants install and boot properly. I've ordered the serial terminal adapter, but it's "in the mail".
When I reloaded armbian on this chip, I now can't boot from armbian. I grabbed an eMMC from another SBC, flashed 190531, and I'm now booting!
Now, it's time to take over the world!
Tim
Oops, I should have said "Now it's time to ask lots of questions ...
I have tried to enable a 2560x1080 mode for my UWHD monitor. The results are a black screen that requires a reboot. Has anyone gotten this to work? Here's my modeline from one of the armbian runs:
# 2560x1080 @ 60.00 Hz hsync: 67.08 kHz; pclk: 230.76 MHz
Modeline "2560x1080_60.00" 230.76 2560 2728 3000 3440 1080 1081 1084 1118 -HSync +Vsync
Any ideas, or is this a "wait for it" moment?
Tim
Is there anything that I can provide to assist? As mentioned before the armbian variants install and boot properly. I've ordered the serial terminal adapter, but it's "in the mail".
When I reloaded armbian on this chip, I now can't boot from armbian. I grabbed an eMMC from another SBC, flashed 190531, and I'm now booting!
Now, it's time to take over the world!
Tim
(06-06-2019, 11:49 AM)Tim Jones Wrote: Now, it's time to take over the world!
Oops, I should have said "Now it's time to ask lots of questions ...
I have tried to enable a 2560x1080 mode for my UWHD monitor. The results are a black screen that requires a reboot. Has anyone gotten this to work? Here's my modeline from one of the armbian runs:
# 2560x1080 @ 60.00 Hz hsync: 67.08 kHz; pclk: 230.76 MHz
Modeline "2560x1080_60.00" 230.76 2560 2728 3000 3440 1080 1081 1084 1118 -HSync +Vsync
Any ideas, or is this a "wait for it" moment?
Tim
