Tutorial[ Seagate Disks ]: Install Seagate OpenSeaChest Utilities

[Neo2018]

It could be an identical situation you have here,
It will depend on the chip that is in the usb/sata controller

I will have to try it.

Another option would be instead of using the v19.01.31 stable, using the last development branch, it has several improvements, but I am not sure if you could pass commands trough pcie:
If using this option:

Code:

mkdir /opt/test && cd /opt/test && git clone --recursive --branch develop https://github.com/Seagate/openSeaChest.git && cd openSeaChest/Make/gcc && make release && cd openseachest_exes

Code:

then check again:
./openSeaChest_Basics --scan --scanFlags interfaceSCSI interfaceATA interfaceUSB sd sgtosd ata scsi -V 4
if don't succeed,
./openSeaChest_Basics --Scan --scanFlags interfaceSCSI interfaceATA interfaceUSB sd sgtosd ata scsi -V 4

My output >

Code:

:/opt/test/openSeaChest/Make/gcc/openseachest_exes# ./openSeaChest_Basics --scan --scanFlags interfaceSCSI interfaceATA interfaceUSB sd sgtosd ata scsi -V 4
==========================================================================================
openSeaChest_Basics - openSeaChest drive utilities - NVMe Enabled
Copyright (c) 2014-2018 Seagate Technology LLC and/or its Affiliates, All Rights Reserved
openSeaChest_Basics Version: 2.8.0-1_19_2 ARM
Build Date: Mar  3 2019
Today: Sun Mar  3 18:35:13 2019
==========================================================================================
Version Info for openSeaChest_Basics:
    Utility Version: 2.8.0
    opensea-common Version: 1.18.0
    opensea-transport Version: 1.19.2
    opensea-operations Version: 1.23.0
    Build Date: Mar  3 2019
    Compiled Architecture: ARM
    Detected Endianness: Little Endian
    Compiler Used: GCC
    Compiler Version: 6.3.0
    Operating System Type: Linux
    Operating System Version: 4.4.154-1132
    Operating System Name: Debian GNU/Linux 9 (stretch)
Bus error

With > ./openSeaChest_Basics --Scan --scanFlags interfaceSCSI interfaceATA interfaceUSB sd sgtosd ata scsi -V 4 > same output
I am desperate and upset
I saved the output of make release. Do you need that, to check. if everything is installed correctly?