02-06-2019, 02:38 PM
Hi,
I got a RockPro64 that I set up about a week ago. Board, EMMC, USB EMMC adapter, power supply, USB serial adapter, heat sink, enclosure, all from the Pine64 online store. I followed the NOOB guide and flashed ayufan's bionic minimal (bionic-minimal-rockpro64-0.7.9-1067-arm64.img) to the EMMC. I was able to connect over the serial console, boot, ssh, etc., everything working great. Didn't power the device down, but did `sudo shutdown -r now` a time or two, no problems.
Then my house lost power for a bit, and it hasn't booted since. The green light where the power connects comes on as it should whenever power is connected. The lights on the ethernet port blink like normal. But whenever I turn it on, the red LED near the power button blinks indefinitely and the white LED there never comes on.
I tried re-flashing the EMMC with the same image I'd used before (I was using dd both times), no improvement.
I tried connecting pins 23 and 25 as the "RockPro64 Main Page" suggests for bypassing SPI, no improvement.
I tried using the "recover" button as described in the "OTG mode" section on the "RockPro64 Main Page", no improvement -- white light never comes on, red light keeps blinking, nothing shows up on a desktop (as reported by lsusb) if I connect it to the USB 3 port.
The USB serial adapter's lights blink when I connect it and turn on the RockPro64, but nothing actually gets sent (as reported by minicom on my desktop, connected the same way I'd connected it successfully before).
I'd very much appreciate any suggestions as to how to troubleshoot this further.
Thanks,
-Joseph
I got a RockPro64 that I set up about a week ago. Board, EMMC, USB EMMC adapter, power supply, USB serial adapter, heat sink, enclosure, all from the Pine64 online store. I followed the NOOB guide and flashed ayufan's bionic minimal (bionic-minimal-rockpro64-0.7.9-1067-arm64.img) to the EMMC. I was able to connect over the serial console, boot, ssh, etc., everything working great. Didn't power the device down, but did `sudo shutdown -r now` a time or two, no problems.
Then my house lost power for a bit, and it hasn't booted since. The green light where the power connects comes on as it should whenever power is connected. The lights on the ethernet port blink like normal. But whenever I turn it on, the red LED near the power button blinks indefinitely and the white LED there never comes on.
I tried re-flashing the EMMC with the same image I'd used before (I was using dd both times), no improvement.
I tried connecting pins 23 and 25 as the "RockPro64 Main Page" suggests for bypassing SPI, no improvement.
I tried using the "recover" button as described in the "OTG mode" section on the "RockPro64 Main Page", no improvement -- white light never comes on, red light keeps blinking, nothing shows up on a desktop (as reported by lsusb) if I connect it to the USB 3 port.
The USB serial adapter's lights blink when I connect it and turn on the RockPro64, but nothing actually gets sent (as reported by minicom on my desktop, connected the same way I'd connected it successfully before).
I'd very much appreciate any suggestions as to how to troubleshoot this further.
Thanks,
-Joseph
