09-09-2018, 04:30 PM
(09-09-2018, 04:54 AM)yasser.moj Wrote:(09-06-2018, 11:59 PM)tllim Wrote:(09-06-2018, 01:51 AM)yasser.moj Wrote:Even you uses the 5V 5A power supply, your cable connection seems not able to deliver the 5A current.(09-05-2018, 11:07 PM)tllim Wrote:(09-03-2018, 02:15 AM)yasser.moj Wrote: I have PineA64 with Ubuntu image installed on SD card. sometimes it fails to startup and get into OS. the HDMI display recognizes the signal but still shows black screen for a while then back to "NO Signal" message. this happens only on startup.
if I plug out / plug in the power cable again, the system works correctly.
This issue occurs many times.
Any solution for that?
Thx for help,
Please make sure your power supply is not under power.
Thanks for your reply.
Actually, I am sure it is not a power issue. because I tried (5V ,2A ) and (5V,5A) but still sometimes (40%) it doesn't get into system.
check this video please:
https://drive.google.com/open?id=1clDSzg...WLlb3k_YmU
here I am using (5V,5A) power supply!!
Please use multimeter and measure on Pi2 bus "DC in" point to check whether you have 5V supply to your board. If you measure only 4.8V, then please revisit your wiring or use the actual 5V 3A power supply.
I've checked it. it is regular 5V and the quality of the cable is good it is Samsung-made.
If Samsung made, then looks like a mobile phone power supply. Please note that most mobile phone power supply not capable of deliver enough power to SBC, even stated 2A rating. This due to the 2A deliver only when "match" to their own mobile phone. If not match happen, the power supply only deliver 500mA.
