How to control the SOPINE UART and SPI pins as GPIO?
#2
Make a backup of current DTB, decompile this DTB into a DTS using dtc compiler, edit DTS to remove any reference to unused SPIs/UARTs, not only their nodes, but also their pins in PinCtrl, save and recompile this modified DTS into DTB, and reboot. All those pins will be defaulted as GPIOs.


Messages In This Thread
RE: How to control the SOPINE UART and SPI pins as GPIO? - by martinayotte - 08-22-2018, 10:15 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  pine64 gpio interrupts fractal 0 8,077 12-09-2024, 07:43 PM
Last Post: fractal
  Tow-boot on Sopine module? poVoq 2 3,143 04-05-2023, 12:48 PM
Last Post: poVoq
  Benchmarking the SOPINE Modules on the Clusterboard clusterDude 4 8,937 08-20-2020, 12:56 PM
Last Post: xmixahlx
  Sopine Fedora 32 on clusterboard w/networking revoman 0 4,025 05-20-2020, 01:23 AM
Last Post: revoman
  SOPINE LTS Availability and Plan aldrich@tulip.co 0 3,406 05-14-2020, 10:00 AM
Last Post: aldrich@tulip.co
  SoPine eMMC compatibility Terra854 4 10,265 02-20-2020, 07:52 PM
Last Post: mcrognale
  Sopine baseboard CSI port camera not work olivaw 2 5,648 02-20-2019, 09:50 AM
Last Post: maya.b
  Is it Sopine, SOPINE, SOPine or SoPine? Pine 2 7,001 01-07-2019, 08:37 AM
Last Post: Pine
  mmc r/w errors after setting GPIO chema 0 3,231 12-02-2018, 05:23 PM
Last Post: chema
  +SOPINE baseboard datasheet is different gamelaster 3 8,231 09-09-2018, 05:08 PM
Last Post: tllim

Forum Jump:


Users browsing this thread: 1 Guest(s)