PINE64   ›   ROCK64   ›   Rock64 Hardware and Accessories   ›   WARNING: internal 10|100 PHY requires magjack hardware!

WARNING: internal 10|100 PHY requires magjack hardware!
den.zavg
Pine Initiate
**
Joined: Jul 2018
Posts: 2

Reputation: 0
#17
07-24-2018, 08:59 PM
I bought a magjack too. But eth1 does not work. I tried Armbian and ayufan's latest release.
I see in the output of the ifconfig command that there are transmitted packets and bytes, but there are no received (RX packets:0     RX bytes:0).

If two jumpers connect the receive to transmit on connector P5 (17+19 and 18+20), the number of bytes received should change?
In my experiment, the number of bytes and packets received was 0.
  Reply


Messages In This Thread
RE: WARNING: internal 10|100 PHY requires magjack hardware! - by den.zavg - 07-24-2018, 08:59 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Any way to tell the rock64's hardware revision? kittyland 1 3,304 07-01-2021, 09:42 PM
Last Post: evilbunny
  Hardware random number generator? scalextrix 13 17,795 06-04-2018, 02:05 AM
Last Post: scalextrix
  Latest Rock64 board hardware revision Ryan 3 5,716 03-14-2018, 05:42 AM
Last Post: petec
Question How can I use the internal 100M ethernet? gabrielmartinslima 1 2,969 02-12-2018, 02:10 PM
Last Post: dkryder
Information Rock64 SSD internal PNY CS900 240GB w/Pine usb|sata adapter MarkHaysHarris777 1 3,998 09-30-2017, 06:48 AM
Last Post: dkryder

Forum Jump:


Users browsing this thread: 7 Guest(s)