05-23-2018, 02:37 PM
Hi guys,
i have Rock64 4gb version and i can't boot new stretch 0.6.41 image (OMV). When i put SD card with flashed image (tried etcher and pine64 installer too ...), there are cycling errors like:
- Buffer I/O error on dev mmcblk1, logical block 0, async page read
- mmc1: tried to reset card
- mmcblk1: error -84 transfering data, sector ....... cmd response 0x900, card status 0x0
and more.
Around after minute device restart, and looping with errors again. I have three 16gb class 10 cards (all the same), but the same result with each. I don't think that it is a problem with cards, because I'm able to boot Jessie OMV image 0.5.15 without problems on any card. When i try to upgrade from 0.5.15, i end up like with flashed 0.6.41 image. I have read a few posts with similar problems, mostly on 4gb boards.
Someone here with 4gb board running new images? Please help and sorry for my english. TY.
i have Rock64 4gb version and i can't boot new stretch 0.6.41 image (OMV). When i put SD card with flashed image (tried etcher and pine64 installer too ...), there are cycling errors like:
- Buffer I/O error on dev mmcblk1, logical block 0, async page read
- mmc1: tried to reset card
- mmcblk1: error -84 transfering data, sector ....... cmd response 0x900, card status 0x0
and more.
Around after minute device restart, and looping with errors again. I have three 16gb class 10 cards (all the same), but the same result with each. I don't think that it is a problem with cards, because I'm able to boot Jessie OMV image 0.5.15 without problems on any card. When i try to upgrade from 0.5.15, i end up like with flashed 0.6.41 image. I have read a few posts with similar problems, mostly on 4gb boards.
Someone here with 4gb board running new images? Please help and sorry for my english. TY.