05-01-2018, 05:16 PM
(05-01-2018, 07:58 AM)Facecreator Wrote: Thanks for the answer.
Have flashed again the spi flash on a SD card. SD card put in, rock turned on. After 5 minutes still no flashing, all 3 LEDs are lit continuously. Also over the serial console with activated FlowControll no improvement. (See the screenshot)
I have no idea what to do anymore.
Ok, from the looks of the screenshot, on HTerm, you need to leave the flow control checkbox off, as it's CTS (hardware) flow control, not software flow control.
I'll run it up on my machine and see if there is anything else that needs changing...
I've seen on another thread a suggestion that the power that bleads through from the USB serial adapter was causing someone else startup issues... maybe unplug the rock64 from the power, and disconnected the TX/RX pins of the adapter from it, wait for a few seconds, and then power the rock64 back up, and then connect to the the TX/RX pins again... see if anything happens then. Perhaps the CPU isn't being started/reset properly due to the power leakage.