Got your PINE64 board yet? Post here!

[Artyom]

Good afternoon, prompt, whether there is on Board (along the curve) traces of mechanical influence (for example behind a protective coating from the Board and so on)? I just want to understand how such a curve can be obtained during transportation are not seriously damaging the outer layer of the Board. I have a serious suspicion that the problem is not in the service delivery and in the plant. You can take foto of the board (front and rear side) and post the photos?

Despite the fact that this photograph (the quality of the way rather not bad for a brilliant subject, thank you), I saw nothing that would indicate damage received when delivered. A bending board is not quite bad. Based on what I saw, I am more inclined to the version of the factory defect. Because no serious injuries pointing to the contrary, I did not see. Talk to tllim. Can Pine64 will replace your board?