02-04-2018, 08:16 AM
(02-02-2018, 08:49 PM)jsfrederick Wrote: I recently ordered 3 EMMC modules from the Pine64 store. Two of the modules work fine, but the third does not work. It is not not recognized by my computer. I am using the official Pine64 EMMC adapter.
How do I go about getting the defective EMMC card replaced?
Thanks!
Sent from my iPad using Tapatalk
I'm also experiencing this issue and am wondering the same about replacing a bad emmc.
I had ordered two pine64 emmc to usb adapters, and two 64gb emmc cards, one flashed fine using etcher, but the other does not. I've tried both adapters with no success. Seems to fail between 5-22% flashing progress, speed decreases until 0 bytes/sec written and then just disconnects the drive. Also tried win32 disk imager with no success.
FWIW - I went through the motions to "clean" the disk with diskpart, and then proceeded to do a Low-Level Format (not quick format) upon which I'm able to see free space on the card again, but the issue with flashing persists.
