Kernel Panic on Rock64 linux

[MarkHaysHarris777]

But How to fix it?

Its actually very easy ( really ).

... you use a 25 watt soldering iron and a tooth pick.  A hot air gun soldering station would be better, but if you don't have that ( they are pricey ) don't worry about it.

Basically you het the component carefully and you use the tooth pic to push it over where it belongs !

The pick&place robot slipped, or the component slipped in the oven. If you heat it and move it back it may work.  Depends on whether any damage occurred.  

Make sure YOU don't create any solder bridges ( you can used solder braid to clean it up if you do ).

( just don't do that )

Give it a shot;  like my old boss used to say, you can't break broke.