07-15-2017, 05:32 AM
does not really matter to me what type it is, push/pull or push/push either way. what's most important and seemingly gets the least amount of thought recently is the position of the slot. take a look at the original pine64 board vs. the pine64 sopine board. pine64 has push/push with card slightly off the edge of the board whereas the sopine has the push/pull with card flush with the board and on the back side of the compute module. sopine slot is close to being one of the most difficult to access. and if you are going to place the slot on the back side then a setup like the original pine64 board , push/push & slightly off the edge of the board. heck after some practice maybe could swap a card without having to remove the compute module.