02-01-2017, 11:36 AM
(02-01-2017, 10:51 AM)utdrmac Wrote: Just ran /usr/local/sbin/pine64_update_kernel.sh and rebooted. Bricked. Nothing is working now. Not even HDMI to monitor is working. Have tried several times to reboot and nothing. What now? How do I recover?
Use the backup image you created before updating...
... <sorry, that was cold> use a serial TTL usb bridge cable ( attached to the EXP header serial console pins ) and monitor the bootup to find out where its failing. Technically, you cannot brick the pine board; just load a good image on a new SD card and start over. It would be difficult to know specifically what happened in your case, but booting up with a serial cable monitor would be helpful.
marcushh777
please join us for a chat @ irc.pine64.xyz:6667 or ssl irc.pine64.xyz:6697
( I regret that I am not able to respond to personal messages; let's meet on irc! )
please join us for a chat @ irc.pine64.xyz:6667 or ssl irc.pine64.xyz:6697
( I regret that I am not able to respond to personal messages; let's meet on irc! )