09-07-2016, 03:22 AM
(This post was last modified: 09-07-2016, 03:23 AM by pfeerick.
Edit Reason: typo
)
(09-06-2016, 11:11 PM)UnixOutlaw Wrote: I'm still confused - if I jumper a switch via EXP PIN4 - where do I jam the other side?
Answer: Other side only needs to connect to another ground pin, so if you don't need it, connect to pin 9 on the ext header. or splice the wire connected to pin 6 so it goes to two switches (or piggyback off the other switch)
Yes, that does look like a busy layout, but this one image consolidates at lot of info from multiple documents into the one page... Is that suitable for A4 print? Making it a good one page reference? What could work out better would be a two sided A4 doc... with the board connectors and headers labelled on the front side, and all the headers broken out on the other, also highlighting GPIO names and busses...
Nice work though... nice to see another approach to the documentation! Maybe it will inspire others to do the same! My only niggle would be the dark blue for GND makes the text almost unreadable... needs to be a lighter background.