08-11-2016, 07:16 PM
(This post was last modified: 08-30-2016, 03:23 AM by pfeerick.
Edit Reason: got my boards crossed ;)
)
(08-11-2016, 06:34 AM)MarkHaysHarris777 Wrote:(08-11-2016, 06:28 AM)xalius Wrote: Since the IR receiver is only wired to the IR receiver input on the A64 the only thing that could be implemented I guess is waking up from sleepmodes (standby) via an interrupt, but not from a hard power-off since for that you would have to wake up the PMIC somehow from a demodulated and decoded IR signal.... same as the standby mode on your TV for example.
Well, and clicking the remote power button (rather than holding it) leaves the PineA64 ON but puts it to sleep. But, the remote will not wake the PineA64 either... takes a reset switch press.
That is to be expected... It puts the pine64 to sleep, which then disables it's ability to be woken up remotely.
The physical power button behaviour *should* be different i.e. it can both put the pine64 to sleep/standby, and wake it up - just like with any Android tablet. So that would mean you could standby or power off the pine64 with the remote, but you have to use the physical button to wake up/ power on the Pine64. 
I'm currently breaking in my new generic 8000mah battery, so it will be a day or two before I can double check on an Android image.
