CR2032 Battery holder - sanity check
#13
Nope, no need for a capacitor. This is a simple battery holder, nothing more exotic.

Common lead is attached to one of the +/- junctions (if you follow the imprint on the case), positive lead , thru the switch, to the other +/- junction.

Going to pick up a couple batteries tomorrow, but just not seeing how you get 3V with them installed as per the case imprints. Install them the same way, and you have two 3V cells in parallel, as I would think was intended.
  Reply


Messages In This Thread
CR2032 Battery holder - sanity check - by xalius - 07-22-2016, 04:30 PM
RE: CR2032 Battery holder - sanity check - by DonFL - 07-23-2016, 07:23 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
Rainbow Lithium battery temperature readout? GregH 0 2,416 03-12-2020, 12:05 AM
Last Post: GregH
  Lithium 3.7 Volt Battery Ron Piggott 49 85,073 07-15-2017, 03:56 PM
Last Post: tllim
  Battery level measurement? HugoRabson 2 5,216 03-08-2017, 06:30 PM
Last Post: pfeerick
  Travelling with the Pine64 (and Lipo battery) psychedup 2 5,858 02-17-2017, 08:18 PM
Last Post: tllim
  Battery temp pin? SvdSinner 1 4,797 12-13-2016, 11:35 AM
Last Post: MarkHaysHarris777
  battery power in android UnixOutlaw 40 68,797 09-25-2016, 07:54 PM
Last Post: tllim
  RTC Backup Battery - CR sbentjies 6 12,100 07-15-2016, 06:35 PM
Last Post: jwouellette
  Battery Datasheet xalius 0 3,022 06-20-2016, 07:38 PM
Last Post: xalius
  Lithium 'salt and battery UnixOutlaw 0 2,937 05-29-2016, 09:32 PM
Last Post: UnixOutlaw
  Minor note about the RTC battery MichaelMeissner 12 23,025 02-18-2016, 05:17 AM
Last Post: German

Forum Jump:


Users browsing this thread: 1 Guest(s)