07-06-2023, 12:55 AM
I'm trying to use the UART adapter as described in :
https://wiki.pine64.org/wiki/PineTab2
But it feels very inconsistent, and I don't really understand it.
When I set it to boot from SD and plug it in, the yellow light turns on and I see a blue light flashing twice now and then.
At this point it doesn't boot anything.
I unplug it all, set it to internal boot and the blue light flashes again but nothing happens. I've had to remove the UART adapter several times, with the internal boot setting before I see an orange light flash and it boots up the pre-installed OS.
I have no idea why it wont boot the SD. Could someone provide any clue to this?
https://wiki.pine64.org/wiki/PineTab2
But it feels very inconsistent, and I don't really understand it.
When I set it to boot from SD and plug it in, the yellow light turns on and I see a blue light flashing twice now and then.
At this point it doesn't boot anything.
I unplug it all, set it to internal boot and the blue light flashes again but nothing happens. I've had to remove the UART adapter several times, with the internal boot setting before I see an orange light flash and it boots up the pre-installed OS.
I have no idea why it wont boot the SD. Could someone provide any clue to this?