can't get quartz64-A working
(04-12-2023, 09:37 AM)jyoung Wrote: I've tried two 12V power supplies, one from an odyssey seeed board and a mini-atx power supply. I've manually checked the voltage on both, and which come out as 12.14V and 11.84V, respectively. In this most recent experiment, I used the atx power supply. To create the images, I'm using dd as such
dd if=Armbian_23.02.0-trunk.0254_Quartz64a_jammy_edge_6.2.0-rc6_minimal.img of=/dev/sdd status=progress
Neither jumper is jumped.
Write down the image with a program (the forum often indicates programs for recording that users use), dd often gives incorrect results and problems at startup (if you need details, why it is not recommended to use dd - see the armbian forum, there is a lot of information there and there is a special topic with details). Show a photo of your jumpers (which are next to the eMMC connector), there should be a jumper on the one closest to the edge, if I don't confuse the prayer, without a jumper, the launch from SD\eMMC will be blocked (disabled).
Quote from WiKI page
********************
Troubleshooting
Stability/Boot Issues With Missing Battery Shunt
If there is no battery plugged into the board, the jumper labelled "ON/OFF_BATT" must be in place. If this is set wrong, stability issues such as failures to boot will occur.
