12-12-2022, 11:48 AM
Hi. I once used pinebook pro with emmc installed armbian without any problem.
but I actually burn motherboard a littlebit as there was kind of electical fault on charging, so I bought new motherboard for pinebook pro and replaced.
and now, It became never booted.
Once Armbian logo and circle appears, it suddenly stucks after few times of circulation.
A funny thing is that when I re-assemble BURNT mainboard again, it boots normally again.
(Only problem is that I can't charge pbp.)
I even tried to install new OS with microsd, but the result was same.
Manjaro, I could only see the splash logo and never booted.
I think I met a little luck, so I actually once succeed on microsd boot, but that was all.
After first-boot setting up, I couldn't do never boot again.
I think I have received a fault production... right?
Ah, I have re-used eMMC module that I used before.
but I actually burn motherboard a littlebit as there was kind of electical fault on charging, so I bought new motherboard for pinebook pro and replaced.
and now, It became never booted.
Once Armbian logo and circle appears, it suddenly stucks after few times of circulation.
A funny thing is that when I re-assemble BURNT mainboard again, it boots normally again.
(Only problem is that I can't charge pbp.)
I even tried to install new OS with microsd, but the result was same.
Manjaro, I could only see the splash logo and never booted.
I think I met a little luck, so I actually once succeed on microsd boot, but that was all.
After first-boot setting up, I couldn't do never boot again.
I think I have received a fault production... right?
Ah, I have re-used eMMC module that I used before.