Audio Pot Board Questions
04-17-2022, 06:54 PM
> ... white 6 pin socket ...
It simply pulls out the signal as shown in the schematic.
Probably, it seems to be a terminal assuming the case of connecting another I2S-device (DAC etc...) to the outside.
> ... which pin is pin 1.
Look at the back of the board, there is a (50M / MCLK) silk mark.
The part where 50M is printed is pin 1.
---
However, even if you select the MCLK side, it will not work properly in many cases.
This is because many kernels are not set to output MCLK to the outside.
You can find such a post by searching the forum thread here.
It simply pulls out the signal as shown in the schematic.
Probably, it seems to be a terminal assuming the case of connecting another I2S-device (DAC etc...) to the outside.
> ... which pin is pin 1.
Look at the back of the board, there is a (50M / MCLK) silk mark.
The part where 50M is printed is pin 1.
---
However, even if you select the MCLK side, it will not work properly in many cases.
This is because many kernels are not set to output MCLK to the outside.
You can find such a post by searching the forum thread here.