PINE64   ›   PINE A64(+)   ›   Pine A64 Hardware, Accessories and POT   ›   EXP Reset pin

Thread Closed 
EXP Reset pin
jproffer
Pine Initiate
**
Joined: Apr 2016
Posts: 18

Reputation: 4
#1
05-04-2016, 07:31 PM
Does the reset pin on the EXP connector (2x5 pins) need to be high or low to reset the board?
martinayotte
Pine Scholar
****
Joined: Apr 2016
Posts: 300

Reputation: 25
#2
05-04-2016, 08:25 PM
According to schematic, it is parallel with the reset switch SW2, and therefore should be bring momentarily to LOW.
jproffer
Pine Initiate
**
Joined: Apr 2016
Posts: 18

Reputation: 4
#3
05-04-2016, 08:31 PM
(05-04-2016, 08:25 PM)martinayotte Wrote: According to schematic, it is parallel with the reset switch SW2, and therefore should be bring momentarily to LOW.

ok. I didnt see that in the schematic, it was just open ended.

thanks
Thread Closed 


Forum Jump:


Users browsing this thread: 1 Guest(s)