06-28-2016, 08:51 AM
Since it is attached on the Pi Header, it is probably using the pin 8 and 10, therefore it is connected to UART2 of the A64 according to PinA64 schematic, so try it with /dev/ttyS2.
|
RaZberry Module (z-wave) need support to get it working!
|
| Possibly Related Threads… | |||||
| Thread | Author | Replies | Views | Last Post | |
|
Z-Wave module pinout to make it compatible with Pi b+ | ebretteville | 59 | 94,270 |
07-12-2019, 08:55 AM Last Post: kris240376 |
|
|
RGB LED Matrix support? | foxnox | 1 | 4,631 |
12-29-2017, 06:52 PM Last Post: psychedup |
|
Z-Wave and openzwave+node-openzwave-shared | saro | 2 | 6,818 |
09-01-2017, 05:22 AM Last Post: saro |
|
|
Is SPI Working? | User 3332 | 64 | 109,238 |
08-12-2017, 03:14 PM Last Post: louwie17 |
| Z-Wave - Full and Low Power Inclusion mode | B34N | 1 | 4,680 |
03-26-2017, 06:03 PM Last Post: B34N |
|
| KICAD Quick Lib and Module Generator | mbt28 | 1 | 5,124 |
02-12-2017, 10:45 PM Last Post: tllim |
|
| Z Wave Module and still using GPIO | bang | 2 | 6,327 |
01-16-2017, 03:12 AM Last Post: bang |
|
| Z-Wave US module with adapter | aegrotatio | 4 | 8,048 |
01-08-2017, 12:03 AM Last Post: aegrotatio |
|
| Dallas 1-Wire Support | ItsDave | 31 | 43,633 |
12-27-2016, 08:30 PM Last Post: ed_mann |
|
| touch screen not working | mike280z | 1 | 4,006 |
12-22-2016, 12:46 PM Last Post: Bluphire |
|
Users browsing this thread: 2 Guest(s)