04-07-2022, 07:16 PM
Carrier: ATT prepaid (US)
APN: NXTGENPHONE
I use Settings -> Mobile Network screen and slide the switch icon to on. Makes a connection to my carrier but no Internet access (I can ping att.com but that's it).
ip link show wwan0
4: wwan0: <POINTOPOINT,MULTICAST,NOARP,UP,LOWER_UP> mtu 1430 qdisc pfifo_fast state UNKNOWN qlen 1000
link/[65534]
"POINTTOPOINT" makes me think of a PPP connection; compare to my Wifi settings:
ip link show wlan0
3: wlan0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP qlen 1000
link/ether 02:ba:93:10:c9:af brd ff:ff:ff:ff:ff:ff
Is there a command (like an option to ip) that I can configure wwan0 as BROADCAST? Where in the NetworkManager startup sequence, or elsewhere in the postmarketOS networking configuration, would I be able to find/change the settings for wwan0?
Surely I'm not expected to make a PPP connection?
Thanks
APN: NXTGENPHONE
I use Settings -> Mobile Network screen and slide the switch icon to on. Makes a connection to my carrier but no Internet access (I can ping att.com but that's it).
ip link show wwan0
4: wwan0: <POINTOPOINT,MULTICAST,NOARP,UP,LOWER_UP> mtu 1430 qdisc pfifo_fast state UNKNOWN qlen 1000
link/[65534]
"POINTTOPOINT" makes me think of a PPP connection; compare to my Wifi settings:
ip link show wlan0
3: wlan0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP qlen 1000
link/ether 02:ba:93:10:c9:af brd ff:ff:ff:ff:ff:ff
Is there a command (like an option to ip) that I can configure wwan0 as BROADCAST? Where in the NetworkManager startup sequence, or elsewhere in the postmarketOS networking configuration, would I be able to find/change the settings for wwan0?
Surely I'm not expected to make a PPP connection?
Thanks
