Need a working image for Quartz64B

[diederik]

That's my guess too, but it could also be an u-boot problem. If another boot loader would have the same issue, then it becomes even more likely to be a HW problem.

[balbes150]

That's my guess too, but it could also be an u-boot problem. If another boot loader would have the same issue, then it becomes even more likely to be a HW problem.

The reason is not u-boot. Before it, a binary blob starts controlling the primary memory configuration, u-boot and EDK2 use almost the same primary blob. There is no output since the start of the primary loader , which means the hardware is not working.

[diederik]

I still need to look further into it, but I had the same issue with a Model-B, no output on both UART adapters (both woodpecker), while both work fine with Model-A.
The Model-B did work fine though (with Plebian), just no output on the serial console.

Yes, I have the same, there is no output to UART,

I think I've found the reason :-)
I have a Model B v1.4 and @CounterPillow appears to have a v1.3 and his serial is working.

Do you happen to have a v1.4 too?

[balbes150]

Ver 1.4 2022.06.06