After the battery of my Pinebook (non-Pro) 14" had a swollen battery I removed it from the case.
But now it seems that it cant boot completly, becuase when armbian IoT (trixie) does start I firstly get some good startup messages and then it does reset and restart in u-boot ans then try to boot armbian trixie again
My Battery is a WTL-400110175 with 7 cables (3x red (PB+) , 3x black (PB- / GND) and in the middle a white or yellow cable (PCM / Overvoltage?)
Did anyone get the normal Pinebook to boot completly without a battery?
Or has anyone build a "new" battery from the old connector and a new 10.00mAh cell?
Something like this: https://www.n11.com/urun/1260110-37v-100...a-87767963
because I couldnt fine only a new battery far away from me for the Pinbook Pro (also 7 Pin)
Thanks for Info in advance
But now it seems that it cant boot completly, becuase when armbian IoT (trixie) does start I firstly get some good startup messages and then it does reset and restart in u-boot ans then try to boot armbian trixie again
My Battery is a WTL-400110175 with 7 cables (3x red (PB+) , 3x black (PB- / GND) and in the middle a white or yellow cable (PCM / Overvoltage?)
Did anyone get the normal Pinebook to boot completly without a battery?
Or has anyone build a "new" battery from the old connector and a new 10.00mAh cell?
Something like this: https://www.n11.com/urun/1260110-37v-100...a-87767963
because I couldnt fine only a new battery far away from me for the Pinbook Pro (also 7 Pin)
Thanks for Info in advance
