08-26-2020, 04:58 PM
(This post was last modified: 08-27-2020, 07:53 AM by tomthetaffer.)
Managed to get myself a Colmi P8. I've successfully used daflasher to transfer the initial bootloader, but I have a quick question.
Do I need to use "make -j `nproc` BOARD=pinetime all" or does this need to be changed to something else?
Are there any other changes I need to make before I flash Wasp-os onto the P8?
Edit: It needed to be "make -j `nproc` BOARD=p8 all"
I've managed to flash the wasp-os bootloader onto the p8, but when I try to flash Micropython.zip unfortunately the watch reboots but stays on the bootloader. I don't seem to have any errors from the nrf transfer sadly
Do I need to use "make -j `nproc` BOARD=pinetime all" or does this need to be changed to something else?
Are there any other changes I need to make before I flash Wasp-os onto the P8?
Edit: It needed to be "make -j `nproc` BOARD=p8 all"
I've managed to flash the wasp-os bootloader onto the p8, but when I try to flash Micropython.zip unfortunately the watch reboots but stays on the bootloader. I don't seem to have any errors from the nrf transfer sadly