First cable for Euler Bus power done!
#25
(10-05-2016, 05:02 AM)pfeerick Wrote:
(10-04-2016, 08:44 PM)Ghost Wrote: I like using arcade PSUs like this one. They're cheap (around £15 - 20), have a selection of voltages including 12V and 5V (the 5V also typically has an adjustment potentiometer that allows anything from 4 - 6V), and I've never had to use dummy loads with them.

Very nice one Ghost! However, I doubt I'd get away with using one here in Australia... we can't even wire a plug ourselves lest we electrocute ourselves... we have to pay an electrician so we can watch him dance and shake instead to do it properly!  Dodgy

Luckily you're kidding, otherwise I'd have to do a surprised-face emoji.
  Reply


Messages In This Thread
RE: First cable for Euler Bus power done! - by Ghost - 10-05-2016, 06:43 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Which Power Supply Unit for Pine64 A64 DB V1.1 2GB REV B (year 2016)? databaseprogrammer 1 3,180 07-03-2021, 01:29 AM
Last Post: tllim
Lightbulb Alternate Power DC-IN on the Euler Bus also with PI filter for batt operation MarkHaysHarris777 13 25,918 12-19-2020, 09:53 PM
Last Post: evilpete
  Once Again: Power Supply problems I guess (Pine A64+ locking up) marcelser 0 3,582 06-04-2018, 03:11 PM
Last Post: marcelser
  Power supply problems. larsen8989 5 9,529 05-03-2018, 09:01 PM
Last Post: tllim
  solar power on a Pine64 tablet Little_Johnny 11 16,163 03-20-2018, 12:01 AM
Last Post: pfeerick
  Power up HDDs c4tich 3 6,476 03-18-2017, 09:18 AM
Last Post: Luke
  Provide power in via Pi-2 header BenCranston 22 30,244 03-08-2017, 10:38 PM
Last Post: pfeerick
  any danger from using 2 power sources at same time? dkryder 3 7,077 01-20-2017, 10:45 PM
Last Post: MarkHaysHarris777
Lightbulb A Tale of Two Power Supplies - why good is good and better is best MarkHaysHarris777 9 18,652 01-07-2017, 11:59 PM
Last Post: aegrotatio
  Correct Voltage For Powering From Euler?? thisrestricted 7 11,487 10-18-2016, 06:49 PM
Last Post: veronicasmithen03

Forum Jump:


Users browsing this thread: 1 Guest(s)