replacing back-screw standoffs
#6
(03-13-2020, 01:56 PM)MIchael Wrote: It's been 30 years since drafting class and if you have any problems reading it let me know.

https://www.dropbox.com/s/blmvy6or9r0hhe...1.jpg?dl=0
https://www.dropbox.com/s/80ld7mvhy32qzw...2.jpg?dl=0
https://www.dropbox.com/s/9n7sdm1ah3r727...1.jpg?dl=0
https://www.dropbox.com/s/6i7genzs6r5246...4.jpg?dl=0
https://www.dropbox.com/s/hscizbic0svesy...0.jpg?dl=0
https://www.dropbox.com/s/q009s69wjfk0vy...8.jpg?dl=0

I know, it's terrible but it should give you a good idea.

Ohhhh, if you tape it down, I don't think you'd need the little alignment tabs. Super Glue might work too.

This is awesome - thanks so much for doing this!!

I'll see about putting this through openscad later this afternoon to get some initial prints done - I'll let you know how it goes.

Thanks again, you're the best!
A64, SOPINE, Rock64, RockPro64, Pinebook1080p, Pinebook Pro, Pinephone, Pinewatch dev kit, Pinetab, Pinecil, Pinenut, Quartz64, Pinephone Pro, and PineNote (so far)


Messages In This Thread
replacing back-screw standoffs - by sundog - 03-12-2020, 07:47 PM
RE: replacing back-screw standoffs - by MIchael - 03-12-2020, 09:47 PM
RE: replacing back-screw standoffs - by sundog - 03-13-2020, 09:46 AM
RE: replacing back-screw standoffs - by MIchael - 03-13-2020, 12:20 PM
RE: replacing back-screw standoffs - by MIchael - 03-13-2020, 01:56 PM
RE: replacing back-screw standoffs - by sundog - 03-13-2020, 02:25 PM
RE: replacing back-screw standoffs - by sundog - 03-16-2020, 07:12 PM
RE: replacing back-screw standoffs - by MIchael - 03-16-2020, 07:56 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  I'm booting from NVME but I want to switch back to eMMC acruhl 4 2,035 04-23-2023, 06:58 AM
Last Post: acruhl
  Replacing Manjero with Ubunto on a PBP john.ismyname 5 3,179 08-23-2022, 05:06 AM
Last Post: KC9UDX
  Back in Stock? bblackburn007 2 4,325 02-19-2020, 05:58 PM
Last Post: Luke
  Boot Issue after replacing EMMC M.Dayle 2 3,808 01-30-2020, 08:32 PM
Last Post: MIchael
  Pinebook missing screw from the factory tso4ev 4 6,376 01-20-2020, 01:25 PM
Last Post: Arwen

Forum Jump:


Users browsing this thread: 1 Guest(s)